Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 103

• The onboard CNA (4 ports) settings on the active server blade and the
standby server blade are the same.
Management module
A0230 or later
Server blade firmware
CB 520X B1: 06-13 or later
CB 520H B3: 08-10 to 08-12
Note: For the firmware versions below, if the Personality setting of the
onboard CNAs (4 ports) on CB 520X B1 and CB 520H B3 is NIC or NIC+RoCE,
the Optional Physical MAC addresses assigned to the onboard CNAs (4 ports)
and the settings of the onboard CNAs (4 ports) on the active server blade can
be inherited. However, N+M cold standby for which iSCSI is specified for the
Personality setting is not supported.
Management module
A0240 or later
Server blade firmware
CB 520X B1: 07-24 or later
CB 520H B3: 08-16 or later
Smart Configure for N+M cold standby
The Smart Configure function is used for N+M cold standby failover to fetch
configuration information into the management module. Before building N+M
cold standby configuration, Smart Configure is executed to acquire
configuration information from the active server blade and store it in the
management module. At N+M cold standby failover, the configuration
information stored in the management module is inherited by the standby
server blade by the operation of Smart Configure, and the standby server
blade starts on the basis of the configuration information. The failed active
server blade may not execute Smart Configure.
Hitachi Compute Blade 500 Series Management Module Setup Guide
Figure 2-11 Smart Configure for N+M cold standby
Functional detail
2-79