Hitachi IJ UX Instruction Manual page 31

● Continuous ejection of ink even though not printing is abnormal. If this occurs, stop ink ejection by pressing the
SHUTDOWN
Shutdown Process Confirmation
Solution 1. To stop the ink jet, press <OK>.
OK
Press No-cleaning stop .
● For a description of subsequent operation, see "3.1.2 When an error occurred at the start of operation".
● At ink ejection, ink may momentarily spurt out and soil the paper. However, this is normal.
Wait until the status changes from "Starting" to "Ready".
5
● When the temperature is low (approximately 20 C or lower), it may take longer than usual for the printer
to enter the "Ready" state.
● Check the Ink pressure.If there is a difference of 0.010 or more from the standard value, adjust the
pressure to the standard value ± 0.002. Refer to Technical manual "6.9 Adjusting tha pressure")
Input the print target detection signal and check whether or not the print state and
6
print description are correct.
●If the print target detection signal is input when the status is "Ready", the set print description is printed.
→ No-cleaning stop .
TEST
START PRINTING
SETTINGS
CONFIRMATION
Shutdown will stop the ink jet.
2. To stop the ink without cleaning, press <No-cleaning stop>.
No-cleaning
stop
Press SHUTDOWN .
SHUTDOWN
LOGIN
×
No.051
Close
●Start operation 3-4