Hitachi IJ UX Instruction Manual page 233

● When the makeup cap was loosened, set it after tightening firmly.
Otherwise the makeup may spill when setting the cartridge bottle.
● After removing the over cap, do not allow your finger, foreign matter or dirt to
get into the hole of the makeup cap. Doing so could cause makeup leakage
and equipment failure.
● Do not change the ink cap of the ink cartridge bottle or makeup cap of the
makeup cartridge bottle. Ink or makeup could spill.
[When IC tag reader is supported]
Hold the cartridge bottle over the RFID reader of the printer so that the IC tag
2
mark of the label on the bottle can be read.
● If the makeup ID is read by the IJ printer, steps
RFID Reader
● If there is still makeup remaining in the Cartridge bottle, do not replace it
even if the Remaining Ink Icon indicates replacement. This could be due to
malfunction on the parts. Contact your nearest service station.
The part may be broken; contact your nearest service station.
● If the makeup cartridge bottle has less than half of its content is set in the
printer, the message "Cartridge replacement error" may be displayed on the
screen. In that case, select the content of makeup cartridge bottle just
replaced according to the guidance displayed on the screern.
● If there is no reaction when you hold the cartridge bottle over the reader of
the printer, the IC tag of the cartridge may be damaged.
In this case, an makeup ID can be input manually from the IJP screen.
(Steps -1 and
2
CAUTION
CAUTION
-2)
2
2 -1 and 2 -2 are not necessary.
IC tag mark
Scan
here
型 式： ＊ ＊ ＊ ＊ ＊
ロッ ト／ LOT： ＊ ＊ ＊ ＊ ＊ ＊
補力液ID／Makeup ID
＊ ＊ ＊ ＊ ＊ ＊ ＊ ＊
開封期限
： ＊ ＊ ＊ ＊.＊ ＊
／Expiration date
部品コー ド
： ＊ ＊ ＊ ＊ ＊ ＊
／Parts Code
Within 30 mm
●Replenishing the makeup 8-9