Hitachi IJ UX Instruction Manual page 215

(5) Copy data from the Upper model to the Lower model
●When the model combinations satisfy those tabulated below in Table 1, "Copy data" to the lower model is
available even if the Print data/User pattern is created on the upper model.
●Refer to "(3) Data copy operation" to copy data after data is stored in USB.
Table 1. Model combinations where Copy data is available
No.
Copy data from Standard model to Basic model
1
[Example] Copy from 6-Lines Standard model to 3-Lines Basic model.
●When the Print data was created on the upper model and "Copy data" was executed to the lower model,
Print data is then classified into 3 different classifications as described in Table 2.
No.
Print data created on the upper model can be used as is on
1
the lower model.
Print data created on the upper model can be used on the
2
lower model by correcting a part of Print data setting.
3 Print data CANNOT be used on the lower model
[EXPLANATORY NOTES OF CLASSIFICATIONS(EXAMPLE)]
Classification No.1: 3-Lines Print data created on 6-Lines machine can be used as is on the 3-Lines machine.
Classification No.2: Print data of Free layout created on the Standard model can be used on the Basic model
by correcting the "Format Setup" to be set to [Individual setup].
Classification No.3: 6-Lines Print data created on the 6-Lines machine can NOT be used on 3-Lines machine.
Model combinations
Table 2. Classifications of Print data
Classifications
Display color of Message name on
"Select message" screen
Black
Brown
Red
●Backing up data to USB memory 7-35