Hitachi IJ UX Instruction Manual page 145

Print specifications
Message name [ ]
1st screen 2nd screen
Product speed matching
Print Target width (mm 0∼9999)
００６０
Actual Print width (mm 0∼9999)
００３０
Speed compensation
Print Target width
12
●Enter "Print Target width" in mm for "Auto".
Input the length of the place over which the print target is detected.
●The Print Target width setting range is from 0 to 9999.
●If "Print Target width" is not entered, the print is made with the same interval as when the Speed match-
ing function is not used.
Actual Print width
13
●Enter "Actual Print width" in mm for "Auto".
●The Actual Print width setting range is from 0 to 9999.
●The value for "Actual Print width" must be smaller than "Print Target width".
●If "Actual Print width" is not entered, the print is made with the same interval as when the Speed
matching function is not used.
The place over which
the print target is detected.
Screen switching
[Stop ]
3rd screen
None Encoder Auto
Disable
Enable
3rd screen of "Print specifications" screen
Print specifications
Message name [ ]
1st screen 2nd screen
Target sensor timer
０００
Target sensor filter
Time setup
Setup value
００５０
Standard(single scan/interlaced)
Ink Drop Charge Rule
Standard(single : It prints by the Single scan or Interlaced.
scan/interlaced)
2015.07.07 12:45
Com=0
Makeup Ink
Startup
Manual
HOME
Actual Print width
13
ABC
Print Target width
12
[Stop ]
3rd screen
（1/10sec 0: none 1∼999）
Until end of print.
(ms 0∼9999)
2015.07.07 12:45
Com=0
Makeup Ink
Manual Startup
HOME
Edit
message
Print
format
Back
●Set the print specifications 4-82