Shutdown (No-Cleaning Stop) - Hitachi IJ UX Instruction Manual

1.4 Shutdown (no-cleaning stop)

When you press the SHUTDOWN
nozzle cleaning sequence. If you repeatedly activate the SHUTDOWN
excessive makeup will enter the printer, thereby thinning the ink or producing an unduly high ink main tank
solution level. If it is absolutely necessary to repeatedly stop the printer operation, use the following procedure.
(For detail the HOME screen, refer to "4.1 Print description screen (initial screen)".)
The no-cleaning stop procedure works even while the startup sequence is being executed.
(The SHUTDOWN
*1: Do not use the SHUTDOWN
*2: When operation was stopped using SHUTDOWN
ink will become stuck in the nozzle and cause ink stream bending, nozzle clogging, and printing
disturbance. Apply makeup to the nozzle orifice to wash it within 30 minutes after a stop to cause the
ink to eject once again.
1 Press SHUTDOWN at HOME screen, and the message "Shutdown Process
Confirmation" appears.
Shutdown Process Confirmation
Solution 1. To stop the ink jet, press <OK>.
OK
2 Press No-cleaning stop on the message "Shutdown Process Confirmation".
2
1-4 ●Shutdown
→ OK is inoperative during the startup sequence.)
TEST
START PRINTING
SETTINGS
CONFIRMATION
Shutdown will stop the ink jet.
2. To stop the ink without cleaning, press <No-cleaning stop>.
No-cleaning
stop
→ OK at HOME screen, the printer stops after completing its automatic
→ OK to stop operation more than two successive times.
→ No-cleaning stop , if left in that state, the
SHUTDOWN
LOGIN
→ OK to stop an operation,
Press SHUTDOWN .
×
No.051
Close