Mitsubishi Electric FX3G SERIES Programming Manual page 67

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
Set item
Positioning table settings will
not be initialized when the PLC
is powered on
Write
Read
*1. Y002 is not available 14-point and 24-point type FX
*2. Note that this item can only be set if two FX
*3. This area can be set only in FX
9
Transferring parameters (and sequence program) to the PLC
1. Select [Online]-[Write to PLC...] from the tool menu to display the "Write to PLC" dialog box.
*1. For Ver. 8.18U to 8.24A of GX Developer, the PLC type is FX3UC.
2. Check mark the "Parameter" box, and click [Execute] button.
The selected contents are transferred to the PLC.
The transferred parameters become valid when the PLC switches from RUN to STOP.
When the communication setting is changed in step 7 "PLC system (2)", cycle the PLC power.
Caution
After changing the memory capacity setting, make sure to write both the programs and parameters to the PLC.
If only the parameters are written to the PLC, program errors (such as parameter error, circuit error and grammar
error) may occur in the PLC.
Contents of setting
A check mark here means not to transfer the positioning setting when PLC turns
ON.
Check mark this box when changing the positioning setting from a display unit,
etc., and then using the changed contents even after restoring power. In this
case, set a latched (battery backed) type device to "Head Address".
This button writes the contents of the positioning table created here to up to
1600 devices (FX and F ) or 1200 devices (FX
3U X3UC
Address".
This button reads the contents of the existing positioning table from all pulse
output destinations, up to 1600 devices (FX
(FX ) starting from "Head Address", but does not read device numbers without
3G
the "positioning instruction" setting.
-2HSY-ADP adapters are connected to the FX
3U
/FX PLCs.
3U 3UC
FX3U(C)*1
2 Overview (Sequence Program)
2.7 Types and Setting of Parameters
) starting from "Head
3G
and FX ) or 1200 devices
3U 3UC
PLC.
3G
This example shows a window in an
FX /FX PLC.
3U 3UC
1
Setting range
–
2
–
–
3
PLC.
3U
4
5
6
7
8
9
10
65