Mitsubishi Electric FX3G SERIES Programming Manual page 606

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
Errors
An operation error is caused in the following cases; The error flag M8067 turns ON, and the error code is stored in
D8067.
• When "n" ("2n" in 32-bit operation) devices starting from
device range (error code: K6706)
• When "n" ("2n" in 32-bit operation) devices starting from
starting from
• When "n" ("2n" in 32-bit operation) devices starting from
starting from
Program example
In the program shown below, the specified number of data stored in D150 to D0 are added to the specified number of
data stored in D100 to D0 when X020 is set to ON, and the operation result is stored in D200 and later.
X020
b15
D100 6789
D101 7821
D102 5432
D103 3520
D0 4
604
D (error code: K6706)
D (error code: K6706)
FNC192
D100 D150
BK+
b0 b15 b0
D150 1234
D151 2032
+
D152 -3252
D153 -1000
25 Block Data Operation – FNC190 to FNC199
, , and/or
S S
1 2
S overlap "n" ("2n" in 32-bit operation) devices
1
overlap "n" ("2n" in 32-bit operation) devices
S
2
D200 D0 When D0 is "4"
END
b15 b0
D200 8023
D201 9853
D202 2180
D203 2520
25.1 FNC192 – BK+ / Block Data Addition
exceed the corresponding
D