FX
/FX
/FX
Series Programmable Controllers
3G
3U
3UC
Programming Manual - Basic & Applied Instruction Edition
Program example
FNC 04
M8000
C255
FNC 06
Interrupt
The rising edge of X000 is detected.
pointer
I001
FNC 03
Interrupt
Interrupt every 20 ms
pointer
I620
FNC 03
Interrupt
High-speed counter
pointer
I010
FNC 03
EI
Main program
FEND
Input interrupt
routine
IRET
Timer interrupt
routine
IRET
High-speed counter
routine
IRET
‚"
8 Program Flow – FNC 00 to FNC 09
8.4 FNC 03 – IRET / Interrupt Return
Interrupts are usually disabled in PLCs.
Use EI instruction to enable interrupts.
When X000 turns ON while the main program is executed,
instructions after the interrupt routine pointer I001 are
executed, and the program execution returns to the original
main program by IRET instruction.
The timer interrupt of the pointer I620 is executed every timer
time of 20 ms, and the program execution is returned to the
original main program by IRET instruction each time.
The high-speed counter interrupt of the pointer I010 is
executed when the current value of a high-speed counter
becomes equivalent to a value specified by DHSCS (FNC 53)
instruction.
The program execution returns to the original main program by
IRET instruction.
Make sure to program an interrupt pointer (I***) as a label after
FEND instruction.
1
2
3
4
5
6
7
8
9
10
233