NEC Xen IPK Programming Manual page 350

December 2004
Programming Procedures
1 Go off-line.
2 Press LK2 + KA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
R
to go to the next Tenant No.
S
to go to the next page
T
to go to the previous page
CO/PBX
Line LED
Data
N
Press to write the data.
4
P
Press to go back on-line.
5
Related Programming
M.B. Number
2-05 Line Key Selection
4-09 Telephone to Tenant Assignment
N
If data is changed while the system is busy, DATA ENTRY is displayed at the programming station until the system
becomes idle.
DRAFT 3
330 – Chapter 1
Off Off
No Yes
(Not Assigned) (Assigned)
Default Values
Tenant
CO/PBX lines 01~64
assigned (YES)
There is no
default setting.
Memory Block Name
NEC Business Solutions Ltd
Tenant
00 01~47
Not
assigned
Trunk to Tenant Assignment, 2-01