Prt B Channel-To-Trunk Group Assignment - NEC Xen IPK Programming Manual

December 2004
PRT B Channel-to-Trunk
Group Assignment
General Description
Use this Memory Block to assign a Trunk Group Number to each B channel or any Trunk
Group for each B channel. Changing this assignment is not normally required and default
should be set. This Memory Block could be used when different trunks are used in the same
PRI span or for a tenant application where multiple tenants share the PRI span and
separation of B channels is required
Display
PRT Data
No. No.
0 1 / 0 5 : B
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK13 + KE
3 Use the following to enter data:
to move the cursor left.
J
to move the cursor right.
L
~ to enter numeric data. (00~30, 00=Not Assigned)
K I
00 is Any Trunk Group
01~32 are Trunk Groups 01~32
N
Press to write the data and display the next B channel or next Memory Block.
4
5 Program the next Memory Block or press
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
1-13-00 PRI Channel Assignment
1-13-04 PRT B Channel Outgoing Priority Selection
3-03 Trunk-to-Trunk Group Assignment
3-91 Trunk Type Selection
N
1. This Memory Block must be coordinated with Memory Block 3-03 (Trunk-to-Trunk Group Assignment). The number of
assigned channels must be the same or greater (including default) than the number of trunks to a trunk group
assigned In Memory Block 3-03.
For Example, When Memory Block 3-03 has five PRT trunks for Trunk Group 1, this Memory Block must have at least
five B channels for Trunk Group 1.
2. This Memory Block applies only to PRT(1)-U( ) ETU firmware version 4.0 or higher.
DRAFT 3
278 – Chapter 1
.
Setting
Setting
Title
Data CO
Data B-
0 1 = T G 0 0
D I S P L A Y
to access the Memory Block.
P
To go back on-line.
Memory Block Name

PRT B Channel-to-Trunk Group Assignment, 1-13-05

NEC Business Solutions Ltd
1-13-05
System Mode
1
Submode
13
Data No.
05
PC Programming
+ AN
Default Values
00, Any Trunk Group