First Digit Pbr Release Timer Selection - NEC Xen IPK Programming Manual

Xen IPK
First Digit PBR Release Timer
Selection
General Description
Use this Memory Block to specify how long a Push Button Receiver (PBR) receiver circuit is
connected when a dual-tone multifrequency (DTMF) Single Line Telephone user goes off-hook.
After the timer expires the PBR is disconnected. If the Single Line Telephone user dials a digit
before the timer expires, a PBR interdigit timer starts.
With IPK R2000 and above, this memory block allows flexible entry and four classes.
For R2000 only.
Display
Data
No.
0 3 : P B R
T I M E
Settings
LK 1 LK 2
10 sec. 20 sec.
LK 5 LK 6
50 sec. 60 sec.
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + KC
3 Press the corresponding CO/PBX line key to change data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
For R2000 and above.
Display
Data
No.
0 3 : P B R
T I M E
Programming Procedures
Go off-line.
1
2 Press LK1 + LK1 + KC

1-3-03, First Digit PBR Release Timer Selection

Setting
Title Data
R L S 1 0 s
D I S P L A Y
LK 3 LK 4
30 sec. 40 sec.
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
Setting
Title
Data
R L S 1 0 s
D I S P L A Y
to access the Memory Block.
Programming Manual
1-3-03
System Mode
1
Submode
3
Data No.
03
PC Programming
+ BTI
DRAFT 3
Chapter 1 – 155