NEC Xen IPK Programming Manual page 244

December 2004
Programming Procedures .
1 Go off-line.9
2 Press LK1 + LK8 +
Press the corresponding CO/PBX line key to change the data option.
3
The LED indication changes to indicate data each time CO/PBX line key is pressed.
CO/PBX
Line Key LED
Data
S
Note: Press
T
Press
N
Press key. Data for Class 01
4
N
Press to write the data for class 15.
5
P
6 Press to go back on-line.
Related Programming
M.B. Number
4-17
N
1. Sixteen Classes (00
restricting others.
2. At default, all stations are in Class 00.
3. Stations are assigned to a Class of Service in Memory Block 4-17 Station to Class of Service Feature
Assignment.
4. LCR/ARS Bypass (Page 3, LK 4) applies only when the station is assigned to an LCR/ARS Class (1~4) in
Memory Block 4-40 (LCR Class Selection). LCR/ARS Bypass does not apply when using access codes to
directly access an ARS Table (functions 601~604 – ARS Tables 1~4) in Memory Blocks 1-1-46~48 [Access
Code (1/2/3-Digit) Assignment].
5. ARS Overflow (Page 6, LK 1) allows or restricts access to Trunk Group 01 when the first priority trunk group
(programmed route) is busy.
Corresponding
CO/PBX Line Key
Page 01
LK1
LK2
LK3
LK4
LK5
LK6
DRAFT 3
224 – Chapter 1
to access the Memory Block.
KH
Off
Deny
to go to the next page.
to go back to the previous page.
15 is displayed successively
~
Station to Class of Service Feature Assignment
15) of feature restriction patterns allow a station user to activate particular features while
~
Function Name
Set Call Forward - All Call, Do Not Disturb (DND),
Break Mode
Trunk Queuing
Automatic Callback
Barge-In Originate on a CO/PBX Line
Barge-In Receive
Timed Alarm (Set/Cancel)
On
Refer to Table on following
page for default settings.
Allow
Memory Block Name
Class of Service (Station) Feature Selection 2, 1-8-08
NEC Business Solutions Ltd
Default Default
Class 00 Class 01
Allow Deny
Allow Deny
Allow Deny
Deny Deny
Allow Deny
Allow Deny
15
~