Acr Max Digit Assignment - NEC Xen IPK Programming Manual

December 2004

ACR Max Digit Assignment

General Description
Use this Memory Block to specify the number of digits to be collected by the system before
the message is sent to the network
System Software R2000 or higher is required.
Display
Data
No.
0 7 : M A X D G T
T I M E
Programming Procedures
1 Go off-line.
Press LK1 + LK14 +
2 KG
3 Use dial pad keys to enter Setting Data
Note: Use the following to enter data:
J to move cursor left.
L to move cursor right.
K ~ I to enter data
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-1-30 Route Advance Block Assignment
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ACR Allow/Deny Selection
1-14-01 ACR Dialling Assignment
1-14-02 ACR Dial Allow/Deny Selection
1-14-03 ACR Route Table Number Assignment
1-14-04 ACR Trunk Group to Route Number Assignment
1-14-05 ACR Digit Delete Assignment
1-14-06 ACR Digit Add Assignment
N
When 00 is set for this Memory Block, refer to Memory Block 1-1-81 (ISDN / K-CCIS Interval Time
1.
Selection) for the time it takes before the message is sent to the K-CCIS Network
ARS Max Digit Assignment applies to K-CCIS Trunk Routes routed through Automatic Route Selection
2.
DRAFT 3
290 – Chapter 1
.
Route Setting
Title
01~32 Data
0 1 = 2 4
D I S P L A Y
to access the Memory Block.
. Default Values
Length = 24 Digits
Valid range for setting data: 01~99
Memory Block Name
ACR Max Digit Assignment, 1-14-07
NEC Business Solutions Ltd
1-14-07
System Mode
1
Submode
14
Data No.
07
PC Programming
+ AM
.
.