Adjusting The Cutting Unit - Toro 04652 Operator's Manual

1. Drive spline
2. Motor mount
5. On the right end of the cutting unit, apply a light
coating of oil to the O-ring and install the counter
weight with the bolts previously removed
Torque the screws to 16 to 20 N∙m (12 to 15 ft-lb).
1. Counter weight

Adjusting the Cutting Unit

1. Support the cutting unit; refer to
Cutting Unit (page
2. Adjust the bedknife to the reel; refer to
Bedknife to the Reel (page
3. Adjust the rear roller height; refer to
Rear-Roller Height (page
4. Adjust the height of cut; refer to
of Cut (page 11).
5. Adjust the cut-off bar; refer to
Bar (page 12).
Figure 8
3. Allen head screw
(Figure
Figure 9
Supporting the
9).
Adjusting the
9).
Adjusting the
10).
Adjusting the Height
Adjusting the Cut-Off
9).
7