Toro 04652 Operator's Manual page 13

Figure 19
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer is no
longer tensioned against the bedbar
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
Figure 20
1. Bedbar bolt
4. Remove each bedbar bolt allowing the bedbar to be
pulled downward and removed from the cutting unit
(Figure 21).
Account for the 2 nylon washers and 1 steel washer on
each end of the bedbar
3. Bedbar
4. Washer
(Figure 19).
(Figure 20).
2. Locknut
(Figure 21).
g020056
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washers and the bedbar-adjusting screw
(Figure 22).
2. Secure the bedbar to each side plate with the bedbar
bolts (nuts on bolts) and 3 washers (6 total).
3. Position a nylon washer on each side of the side-plate
boss. Place a steel washer outside each of the nylon
washers (Figure
4. Torque the bedbar bolts to 27 to 36 N∙m (240 to 320
inch-lb).
5. Tighten the locknuts until you remove the end play
from steel washers, but you are able to rotate them by
hand. The washers on the inside may have a gap.
Important: Do not overtighten the locknuts or
they will deflect the side plates.
6. Tighten the spring tension nut until the spring is
collapsed, then back it off 1/2 turn
1. Spring-tension nut
13
Figure 21
3. Nylon washer
4. Steel washer
21).
(Figure
Figure 22
2. Spring
22).