Table of Contents
Advertisement
Product Overview
Specifications
Tractors
Height of Cut
Height-of-Cut Range
Cutting Width
Reel Bearings
Rollers
Bedknife
Bedknife Adjustment
Grass Shield
Counterweight
Net Weight
Attachments/Accessories
A selection of Toro approved attachments and accessories is available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
To best protect your investment and maintain optimal performance of your Toro equipment, count on Toro genuine parts.
When it comes to reliability, Toro delivers replacement parts designed to the exact engineering specification of our equipment.
For peace of mind, insist on Toro genuine parts.
Operation
Refer to your traction unit Operator's Manual for detailed operation instructions. Before using the cutting unit each day, adjust the
bedknife; refer to
Adjusting the Bedknife Daily (page
unit on a green to ensure that the finished cut is correct.
Greensmaster 3120, 3150, 3250-D, and 3150-Q Traction Units.
Adjust on the front roller using 2 vertical screws and held 2 locking screws.
Standard bench height-of-cut range is 1.6 mm (0.062 inch) to 12.7 mm (0.500 inch). Bench
height-of-cut range with the High Height of Cut Kit installed is 7 mm (0.285 inch) to 25 mm
(1.00 inch). Effective height of cut may vary depending on turf conditions, type of bedknife,
rollers, and attachments installed.
53 cm (21 inches)
Two sealed stainless steel, deep groove ball bearings
The rear roller is a 5.1 cm (2 inch) diameter steel full roller.
Replaceable single edged, high carbon steel bedknife is fastened to a machined cast iron
bedbar with 13 screws
Dual-screw adjustment to the reel; detents corresponding to 0.018 mm (0.0007 inch)
bedknife movement for each indexed position
Non-adjustable shield with adjustable cut-off bar to improve grass discharge from reel in
wet conditions
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
8 Blade—30 kg (65 lb), 11 Blade—31 kg (68 lb), 14 Blade—32 kg (71 lb)
9). Test the quality of cut by cutting a test swath before using the cutting
8
Advertisement
Table of Contents
