Repositioning The Counter Weights - Toro 04652 Operator's Manual

G020064
1. Hoop link
•
For the Greensmaster 3250-D traction units, install the
offset link (Part No. 110-2397) supplied with the traction
unit.
Install the offset link
unit with 2 bolts. Torque the bolts to 34 to 40 N∙m (25
to 30 ft-lb).
Important: Position the lift hook offset towards the
front of the cutting unit.
1. Offset lift hook
•
Optionally for the Greensmaster 3250-D traction units,
you can install the chain Link (Part No. 106-2601) and
mounting bracket (Part No. 105-5738) available from
your Toro Distributor.
Figure 5
(Figure 6) to the top of the cutting
G020065
Figure 6
Install the chain link
unit with the mounting bracket and 2 bolts. Torque the
bolts to 34 to 40 N∙m (25 to 30 ft-lb).
Note: When mounting the cutting unit to the traction
unit, hook the wider end of the chain link to the lift arm.
2
1. Chain link
Repositioning the Counter
Weights
The cutting units are shipped with the counter weight
mounted to the left end and the motor mount to the right end
of the cutting unit. To change the cutting unit to different
positions, proceed as follows:
Important: Whenever you need to tip the cutting unit
on its side, ensure that you prop it up to avoid damaging
the bedbar-adjusting screws; refer to
Cutting Unit (page 9)
1. Remove the 2 bolts securing the counter weight to the
left end of the cutting unit. Remove the counter weight
(Figure 9).
2. Remove the 2 Allen head screws securing the motor
mount to the left end of the cutting unit. Remove the
motor mount (Figure
3. Apply grease to the inside diameter of the drive spline
(Figure 8).
4. On the left end of the cutting unit, apply a light coating
of oil to the O-ring and install the motor mount with
the 2 Allen head screws previously removed
Torque the screws to 16 to 20 N∙m (12 to 15 ft-lb).
6
(Figure 7) to the top of the cutting
1
g011932
Figure 7
2. Mounting bracket
Supporting the
8).
(Figure 8).