Installing The Roll Bar; Installing The Seat - Toro 04540 Operator's Manual

1

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar
4 Bolt (1/2 x 3-3/4 inches)
4 Flange-nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Install the roll bar into the pockets on each side of
the machine, using 4 bolts (1/2 x 3-3/4 inches) and 4
flange-nuts (1/2 inch)
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 136 to 149 N∙m (100 to 110
ft-lb).
(Figure 3).
1
2
3 g014601
Figure 3
3. Flange-nut (1/2 inch)
2

Installing the Seat

Parts needed for this procedure:
1 Seat
1 Seat wiring harness
Procedure
Note: Mount the seat in the front set of mounting holes to
gain an additional 7.6 cm (3 inches) in the forward adjustment,
or in the rear mounting holes for an additional 7.6 cm (3
inches) in the rearward adjustment.
1. Remove and discard the lag bolts securing the seat
slides and cut the shipping straps.
2. Remove the 4 bolts (5/16 x 3/4 inch) and washers
from the shipping bracket and discard the bracket.
3. Secure the seat to the seat base with 4 bolts and washers
removed previously
1. Seat
2. Seat base
4. Locate the open connector on the main wiring harness
to the right of the seat and connect it to the wiring
harness that came with the seat.
5. Route the seat wiring harness around the seat slides,
ensuring that it will not be pinched when the seat
moves, and connect it to the port on the bottom of
the seat.
12
(Figure 4).
Figure 4
3. Washer
4. Bolt (5/16 x 3/4 inch)