Table of Contents
Advertisement
Installing and Removing the
Cutting Units
Note: When sharpening, setting the height-of-cut, or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the storage location
on the front of the suspension arms to prevent damage to
them.
Important: Do not raise the suspension to the transport
position when the reel motors are in the holders in the
machine frame. Damage to the motors or hoses could
result.
Important: Whenever you need to tip the cutting unit,
prop up rear of cutting unit to ensure that the nuts on
the bedbar adjusting screws are not resting on work
surface
(Figure
29).
g014596
Figure 29
1. Prop (not provided)
2
2
1
2. Bedbar-adjusting-screw
nut (2)
Installing the Electrical Counterweights
Secure the electrical counterweight to the existing
counterweight with 2 capscrews as shown in
1. Capscrew
2. Electrical counterweight
Installing the Cutting Units
1. Disconnect the cutting unit power disconnect couplers;
refer to
Cutting Unit Power Disconnect Connectors
(page
22).
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
2. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
29
Figure
Figure 30
3. Existing counterweight
(Figure
30.
31).
Advertisement
Table of Contents
