Table of Contents
Advertisement
1
1. Traction pedal—forward
2. Traction pedal—reverse
Figure 12
Ground speeds are as follows:
•
3.2 to 8 km/h (2 to 5 mph) forward mowing speed
•
16 km/h (10 mph) maximum transport speed
•
4.0 km/h (2.5 mph) reverse speed
Steering-Arm-Locking Pedal
Press the pedal
(Figure
11) and raise or lower the steering
arm for operator comfort, then, release the pedal to lock the
arm in place.
Throttle Lever
The throttle lever
(Figure
of the engine. Move the throttle lever toward the F
position to increases the engine speed; move it toward the
S
position to decrease the engine speed.
LOW
Note: You cannot stop the engine cannot using the throttle
lever.
2
Figure 11
3. Steering arm locking pedal
13) allows you to control the speed
3
g014603
1. Ignition switch
2. Choke lever
3. Functional-control lever
Choke Lever
To start a cold engine, close the carburetor choke by pushing
the choke lever
After the engine starts, regulate the choke lever to keep the
engine running smoothly. As soon as possible, open the
choke by pulling the lever rearward to the O
warm engine requires little or no choking.
Raise/Lower Mow Control
Moving the control
lowers the cutting units and starts the reels. Pull back on the
control to stop the reels and raise the cutting units. During
operation the reels can be stopped by pulling back on the
control momentarily and releasing it. Start the reels by
moving the control forward.
Functional Control Lever
The functional control lever
selections plus a N
from mow to transport or transport to mow (not to neutral)
while the machine is in motion. No damage will result.
•
R
Position—neutral and backlapping
EAR
•
M
IDDLE
•
F
Position—used for transport operation
RONT
AST
17
Figure 13
4. Raise/Lower mow control
5. Throttle lever
6. InfoCenter control
forward(Figure
13) to the C
(Figure
13) forward during operation
(Figure
13) provides 2 traction
position. It is permissible to shift
EUTRAL
Position—used for mowing operation
position.
LOSED
position. A
PEN
Advertisement
Table of Contents
