Installing The Grass-Basket Hooks; Installing The Cutting Units; Setting The Clip-Control Feature; Adding Rear Weight - Toro 04540 Operator's Manual

6
Installing the Grass-Basket
Hooks
Parts needed for this procedure:
6 Grass-basket hook
12 Flange bolts
Procedure
Install the 6 grass-basket hooks onto the ends of the
suspension-arm bars using the 12 flange bolts
1. Flange bolt
2. Grass-basket hook
7

Installing the Cutting Units

Parts needed for this procedure:
1 Gauge bar
3 Cutting unit (obtain from your Toro Distributor)
3 Grass basket
3 Electric-reel-motor counterweight
6 Capscrew
Procedure
1. Setup the cutting units as described in the cutting unit
Operator's Manual.
2. Apply grease to the inside diameter of the drive coupler.
(Figure
Figure 9
3. Suspension-arm bar
3. Install the electric-reel-motor counterweight as
described in
(page 29).
4. Install the cutting units as described in
Cutting Units (page
8
Setting the Clip-Control
Feature
No Parts Required
9).
Procedure
To achieve a consistent, high quality-of-cut and a uniform
after cut appearance, the machine has a clip-control feature
that varies the speed of the reels with the speed of the
machine, to maintain a constant clip. This feature is O
default; to configure it and turn it O
Clip-Control Feature (page 15)
9

Adding Rear Weight

Parts needed for this procedure:
1 Weight kit, 119-7129 (purchase separately)
Procedure
This unit complies with the ANSI B71.4-2012 and EN ISO
5395:2013 Standards when equipped with the Weight Kit,
Part No. 119-7129.
10

Installing EU Decals

Parts needed for this procedure:
1 Warning decal, 133-2339
Procedure
If this machine will be used in the EU, affix the warning-decal
133-2339 over English warning-decal 133-2338.
15
Installing the Electrical Counterweights
29).
, refer to
N
Installing the
by
FF
8 Setting the