Toro 04540 Operator's Manual page 30

1
Figure 31
1. Footrest—closed
3. Position the cutting unit under the center suspension
arm.
4. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure
down so that the bar fits over the bar across the top of
the cutting unit (Figure
1
Figure 32
1. Latch—closed position
2. Suspension-arm bar
Figure 33
1. Suspension-arm bar
5. Close the latches down and around the cutting-unit bar
and lock them in place
2
2. Footrest—open
32), push the suspension arm
33).
2
3. Latch—open position
2. Cutting-unit bar
(Figure 32).
Note: A "click" can be heard and felt when the latches
are properly locked in place.
6. Coat the spline shaft of the cutting unit motor with
clean grease
7. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
g014602
of the motor
3
g014609
1. Reel motor
2. Spline shaft
8. Mount a grass basket onto the basket hooks on the
suspension arm.
9. Repeat this procedure for the other cutting units.
10. Connect the cutting unit power disconnect couplers;
refer to
(page 22).
30
(Figure 34).
(Figure 34).
Figure 34
3. Cavity
4. Motor-retaining bar
Cutting Unit Power Disconnect Connectors