Table of Contents
Advertisement
3
Installing the Steering Wheel
Parts needed for this procedure:
1
Steering wheel
1
Locknut (1-1/2 inches)
1
Washer
1
Steering-wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft
5).
g014687
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft
3. Secure the steering wheel to the shaft with a locknut
and tighten it to 27 to 35 N∙m (20 to 26 ft-lb)
4. Install the cap to the steering wheel and secure it with 6
bolts
(Figure
5).
4
Activating and Charging the
Battery
No Parts Required
Procedure
Use only electrolyte (1.265 specific gravity) to fill the battery
initially.
4
3
2
1
Figure 5
3. Locknut
4. Cap
(Figure
(Figure
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
1. Remove the fasteners and battery clamp and lift out
the battery.
Important: Do not add electrolyte while the
battery is in the machine. You could spill it,
causing corrosion.
(Figure
2. Clean the top of the battery and remove the vent caps
(Figure
3. Carefully fill each cell with electrolyte until the plates
are covered with about 6 mm (1/4 inch) of fluid
5).
7).
5).
1. Electrolyte
4. Allow approximately 20 to 30 minutes for the
electrolyte to soak into the plates. Fill as necessary to
13
WARNING
CALIFORNIA
Proposition 65 Warning
Wash hands after handling.
6).
Figure 6
Figure 7
(Figure
Advertisement
Table of Contents
