Activating And Charging The Battery - Toro 04356 Operator's Manual

Description
Gauge bar
Screw, #10 x 5/8 in.
Jam nut, #10
Grass basket
Ignition keys
Warning decal
Danger decal
Service decal
Operator's Manual (traction unit)
Engine Operator's Manual
Operator video
Parts Catalog
Noise rating certificate
Pre-delivery sheet
Certificate of Compliance
Registration Card (traction unit)
Registration Card (cutting unit)
Note: Mounting fasteners for the Greensmaster 3100 cutting unit are included with the cutting units.
Remove the shipping bracket and nut secured to rear wheel bolt.
Note:
Activating and Charging the
Battery
Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Voltage: 12 v, 32 amp. hour
Qty. Use
1
1 Setting the height-of-cut
1
3 Mounts to the pull frame
2
Affix over English warning decal (104-2053) for
1
CE.
Affix over English danger decal (62-5070) for
3
CE.
Affix appropriate language decal over English
11
service decal (94-8036) for CE.
2
Read before operating the machine.
1
1 Watch before operating the machine.
1
1
1
1
1
Fill out and return to Toro.
1
Battery electrolyte contains sulfuric acid which is a
deadly poison and causes severe burns.
Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and rubber gloves to protect
your hands.
Fill the battery where clean water is always
available for flushing the skin.
1. Remove the wing nuts, washers, and battery clamp and
lift out the battery.
2. Remove the filler caps from the battery and slowly fill
each cell until the electrolyte is up to the fill line.
3. Replace the filler caps and connect a battery charger to
the battery posts. Charge the battery at a rate of 3 to
4 amperes for 4 to 8 hours.
10
Danger