Installing The Steering Wheel; Activating And Charging The Battery - Toro Greensmaster TriFlex 3420 Operator's Manual

1. Seat
2. Seat base
4. Locate the open connector on the main wiring
harness to the right of the seat and connect it to
the wiring harness that came with the seat.
5. Route the seat wiring harness around the seat
slides, ensuring that it will not be pinched when
the seat moves, and connect it to the port on
the bottom of the seat.
3
Installing the Steering
Wheel
Parts needed for this procedure:
1 Steering wheel
1 Locknut (1-1/2 inches)
1 Washer
1 Steering-wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft
(Figure 5).
Figure 4
3. Washer
4. Bolt (5/16 x 3/4 inch)
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft
g193736
5).
3. Secure the steering wheel to the shaft with a
locknut and tighten it to 27 to 35 N∙m (20 to 26
ft-lb) (Figure
4. Install the cap to the steering wheel and secure
it with 6 bolts
4
Activating and Charging
the Battery
No Parts Required
Procedure
Use only electrolyte (1.265 specific gravity) to fill the
battery initially.
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm. Wash
hands after handling.
1. Remove the fasteners and battery clamp and
lift out the battery.
14
Figure 5
3. Locknut
4. Cap
5).
(Figure 5).
WARNING
CALIFORNIA
g014687
(Figure