Premaintenance Procedures; Jacking The Machine; Lubrication - Toro 08703 Operator's Manual

Premaintenance
Procedures
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers

Jacking the Machine

CAUTION
Before servicing, support the machine with jacks
stands or blocks of wood.
The jacking points are as follows:
•
Left or right side-under the rear wheel motor or the frame
(Figure 19).
Figure 19
1. Rear jacking points
•
Front-under the frame behind the front wheel (Figure 20).
Figure 20
1. Front jacking points

Lubrication

The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease
after every 100 hours of operation.
Lubricate the following bearings and bushings:
•
Front wheel bearing (1) (Figure 21)
•
Traction pedal pivot (1) (Figure 22)
•
Rear hitch (5) (Figure 23)
25
Figure 21
Figure 22
Figure 23