Premaintenance Procedures; General Safety; Lubrication; Greasing The Machine - Toro 25430A Operator's Manual

Premaintenance
Procedures

General Safety

WARNING
Improperly servicing or repairing the machine can
cause injury or death.
If you do not understand the service procedures for
this machine, contact an Authorized Toro Service
Dealer or the service manual for this machine.
WARNING
Raised equipment on the machine without an
operator can cause injury or death.
Before you leave the operating area, always support
or lower the equipment to the ground and stop the
engine.
WARNING
Replace all covers and guards after you service or
clean the machine. Never operate the machine
without the covers or guards in place.
1. Park the machine on a level surface.
2. Lower all attachments and stop the engine, and remove
the key.
3. Allow the engine to cool 2 or 3 minutes.
4. Remove the right-side panel; refer to Removing the
Side Panels (page 35).
5. Rotate the battery-disconnect switch to the Off
position.

Lubrication

Greasing the Machine

Grease Type: Lithium-based grease.
Greasing the Front and Rear Axles
Service Interval: Every 200 hours
1. Clean the grease fittings with a rag.
2. Connect the grease gun to the grease fittings for the
upper and lower pivots; apply 2 or 3 pumps of grease
to each fitting (Figure 30 and Figure 31).
Note: There are 2 grease fittings at the axle pivot for
each tire.
1. Grease fitting (upper pivot) 2. Grease fitting (lower pivot)
33
Figure 30
Front axle