Sound Pressure Level; Sound Power Level; Vibration Level - Toro 04383 Operator's Manual

Traction unit

Hide thumbs Also See for 04383:

Operator's manual (52 pages)

Operator's manual (52 pages)

Operator's manual (40 pages)

Table Of Contents

Table of Contents

Enlarged version

The grass baskets must be in place during operation of

the reels or thatchers for maximum safety. Shut the

engine off before emptying the baskets.

Raise the cutting units when driving from one work

area to another.

Do not touch the engine, muffler, or exhaust pipe while

the engine is running or soon after it has stopped

because these areas could be hot enough to cause burns.

Stay clear of the rotating screen at the side of the engine

to prevent direct contact with your body or clothing.

If the engine stalls or loses headway and cannot make it

to the top of a slope, do not turn the machine around.

Always back slowly, straight down the slope.

When a person or pet appears unexpectedly in or near

the mowing area, stop mowing. Careless operation,

combined with terrain angles, ricochets, or improperly

positioned guards can lead to thrown object injuries. Do

not resume mowing until the area is cleared.

Before getting off of the seat, move the functional

control lever to neutral (N), raise the cutting units and

wait for the reels to stop spinning. Set the parking

brake. Stop the engine and remove the key from the

ignition switch.

Whenever the machine is left unattended, make sure

that the cutting units are fully raised and the reels are

not spinning, the key is removed from the ignition

switch, and the parking brake is set.

Maintenance and Storage

Make sure all hydraulic line connectors are tight and all

hydraulic hoses and lines are in good condition before

applying pressure to the system.

Keep your body and hands away from pin hole leaks or

nozzles that eject hydraulic fluid under high pressure.

Use paper or cardboard, not your hands, to search for

leaks. Hydraulic fluid escaping under pressure can have

sufficient force to penetrate the skin and cause serious

injury.

Before disconnecting or performing any work on the

hydraulic system, all pressure in the system must be

relieved by stopping the engine and lowering the cutting

units and attachments to the ground.

Check all fuel lines for tightness and wear on a regular

basis. Tighten or repair them as needed.

If the engine must be running to perform a maintenance

adjustment, keep hands, feet, clothing, and any parts of

the body away from the cutting units, attachments, and

any moving parts, especially the screen at the side of the

engine. Keep everyone away.

The engine must be shut off before checking the oil or

adding oil to the crankcase.

To ensure safety and accuracy, have an Authorized Toro

Distributor check the maximum engine speed with a

tachometer. Maximum governed engine speed should be

2900 RPM.

If major repairs are ever needed or if assistance is

desired, contact an Authorized Toro Distributor.

Use only Toro-approved attachments and replacement

parts. The warranty may be voided if used with

unapproved attachments.