Installing The Front Wheels; Installing The Rear Wheel; Mounting The Seat; Activating And Charging The Battery - Toro 04383 Operator's Manual

Installing the Front Wheels

Mount the front wheels and torque the mounting nuts to
70–90 ft.-lb.

Installing the Rear Wheel

1. Mount the wheel hub to the rear wheel rim with 4
mounting nuts (Fig. 2). Torque the nuts to 70–90 ft.-lb.
2. Remove the wheel bolt and locknut from the wheel
mounting holes in the rear castor fork (Fig. 2).
3. Install the rear wheel into the castor fork. Insert the
wheel bolt into one of the castor fork mounting holes,
install a spacer (supplied in loose parts), and slide the
bolt through the wheel.
4. Install another spacer onto the bolt and route the bolt
through the remaining castor fork mounting hole.
1
3
2
Figure 2
1. Rear wheel
2. Hub
3. Nut
5. Position the bend of the wheel bolt head under the
bottom edge of the adapter plate (Fig. 2). Install and
tighten the locknut to secure the wheel to the castor
fork. Do not overtighten the locknut as the wheel must
rotate freely.
6. Wipe the grease fitting clean on the wheel assembly.
Pump grease into the wheel hub until grease is seen
exiting at both hub bearings. Wipe up excess grease.
4
5
6
4. Rear castor fork
5. Wheel bolt
6. Spacer (2)
13

Mounting the Seat

Note: Mount the seat slides in the front set of mounting
holes to gain an additional 3 in. (7.6 cm) in the forward
adjustment, or in the rear mounting holes for an additional
3 in. (7.6 cm) in the rearward adjustment.
1. Remove the locknuts securing the seat slides to the
plywood shipping base. Discard the locknuts.
2. Connect the wire harness to the seat switch.
3. Secure the seat slides to the seat support with 4 locknuts
(5/16 in.) supplied in the loose parts (Fig. 3).
Figure 3
1. Seat support
Activating and Charging the
Battery
Use only electrolyte (1.265 Specific Gravity) to fill battery
initially.
1. Remove the battery from the machine.
Important
Do not add electrolyte while the battery is in
the machine. You could spill it, causing corrosion.
2
1
2. Seat slide