Toro 04383 Operator's Manual page 18

4. Thread a ball stud into each end of the cutting unit front
roller (Fig. 17).
Figure 17
1. Ball stud
5. Slide the cutting unit under the pull frame while
hooking the lift roller onto the lift arm. To facilitate
installation of the rear cutting unit, the pull frame can
be rotated and latched into a service position:
A. Lower the suspension system completely (cylinders
extended).
B. Lift the carrier frame by hand until the anti-scalp
rollers clear the brake linkage.
C. Lift up on the slotted link and rotate the pull frame
into the wire hook (Fig. 18).
2
Figure 18
1. Slotted link
D. With the cutting unit in position, release the wire
hook and rotate the pull frame to the operating
position.
E. The slotted link locks automatically.
F. Attach the motor and pull links.
1
1
2. Wire hook
18
Important
Do not operate the lift system when the
center cutting unit is in the service position. Damage could
result to the pull frame and clevis assembly.
6. Slide the sleeve back on each ball joint receiver and
hook the receiver onto the cutting unit ball stud
(Fig. 19).
1
6.62 in. (168 mm)
2
Figure 19
1. Pull link extension
2. Pull arm
Note: The pull link assemblies are preset at the factory. If
they ever need to be disassembled, reassemble them to the
dimensions shown in Figure 19.
7. Mount the basket onto the carrier frame.
8. Adjust the pull links until there is 1/4 to 3/8 in. (6 to
9 mm) clearance between the lip of the basket and the
reel blades. Make sure the basket lips are equidistant
from the reel blades all the way across the reel blades.
9. Assemble the mounting screws for the reel drive motor
to each cutting unit. Leave approximately 1/2 in.
(13 mm) of the threads exposed on each mounting
screw (Fig. 20).
3
3. Ball joint receiver