Toro 04383 Operator's Manual page 17

Note: An optional Lift Hook, Toro Part No. 106–6938 may
be used in place of the chain link, if desired (Fig. 13). It
may be obtained from your local Toro Distributor.
1
Figure 13
1. Lift hook
A. All cutting units are shipped with the counter weight
mounted to the left end and the motor mount and
drive coupler mounted to the right end of the cutting
unit. To mount the cutting unit in the right front
position, proceed as follows:
B. Remove the 2 capscrews securing the counter
weight to the left end of the cutting unit. Remove
the counter weight (Fig. 14).
Figure 14
1. Counter weight
C. On right end of cutting unit, remove plastic plug
from bearing housing (Fig. 15).
D. Remove the 2 allen head screws securing the motor
mount to the right end of the cutting unit. Remove
the motor mount (Fig. 15).
1. Motor mount
2. Plastic plug
E. Remove the snap ring securing the drive coupler in
the reel tube (Fig. 16). Remove the drive coupler.
1
1. Snap ring
F. Apply grease to the inside diameter of the drive
coupler. Install the drive coupler to the left end of
the cutting unit reel tube with a snap ring.
G. Install the motor mount to the left end of the cutting
unit with the (2) allen head screws previously
removed. Torque screws to 12–15 ft–lbs. (16–20
N m).
H. Install the counter weight to the right end of the
cutting unit with the screws previously removed.
3. The cutting unit is shipped without a front roller. Obtain
a roller (Model No. 04625, 04626 or 04627) from your
local Toro Distributor. Install the roller using the loose
parts supplied with the cutting unit and installation
instructions included with the roller.
17
1
2
3
Figure 15
3. Allen head screw (2)
1 2
Figure 16
2. Drive coupler