Toro 22615 Operator's Manual page 12

6. Raise the cutting wheel, release the parking brake, and
move the machine forward a few centimeters (inches).
Set the parking brake.
7. Repeat steps 5 and 6 until you have completely
removed the stump (E through H in
8. Move throttle to the D
handle down enough to raise the cutting wheel off the
ground. Wait for the cutting wheel to stop rotating
then release the parking brake and pull the machine
away from the stump.
Note: Do not let the front of the unit touch the
ground until you are sure the cutting wheel has stopped
turning.
9. Shut off the engine; refer to
(page 10).
Figure 9).
position, push the
ISENGAGE
Shutting Off the Engine
12