Checking The Hydraulic Lines And Hoses; Cutting Deck Maintenance; Separating The Cutting Decks From The Traction Unit - Toro 30807 Operator's Manual

Checking the Hydraulic Lines
and Hoses
Service Interval: Before each use or daily
Check hydraulic lines and hoses for leaks, kinked lines, loose
mounting supports, wear, loose fittings, weather deterioration,
and chemical deterioration. Make all necessary repairs before
operating.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure all hydraulic fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
• Seek immediate medical attention if fluid is
injected into skin.
Cutting Deck
Maintenance
Separating the Cutting Decks
from the Traction Unit
1. Position the machine on a level surface, lower the
cutting decks to the floor, shut the engine off, and
engage the parking brake.
2. Disconnect and remove the hydraulic motor from
the deck (Figure 67). Cover the top of the spindle to
prevent contamination.
1. Motor mounting screws
3. Remove the lynch pin or retaining nut securing the
deck carrier frame to the lift arm pivot pin (Figure 68).
1. Lynch pin
4. Roll the cutting deck away from the traction unit.
52
Figure 67
Figure 68
2. Lift arm pivot pin