Specifications; Attachments/Accessories; Operation; Checking The Engine Oil Level - Toro 30807 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Traction Unit
Overall Width - 68 inch width
of cut
Overall Width - 72 inch width
of cut
Length
Height to top of ROPS
Wheel Base
Track Width
Ground Clearance
Weight with cutting units
Models 30839,
30843 and 30807
Model 30849
Cutting Deck
Length
Width
Height
Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
182 cm (71.8 inches)
193 cm (75.8 inches)
295 cm (116 inches)
180 cm (70.8 inches)
149 cm) (58.5 inches)
145 cm (57 inches)
15.3 cm (6 inches)
963 kg (2,124 lb)
952 kg (2,099 lb)
86.4 cm (34 inches)
86.4 cm (34 inches)
24.4 cm (9.6 inches)
to carrier mount
26.7 cm (10–1/2 inches)
at 3/4 inch height of cut
34.9 cm (13–3/4 inches) at
4 inch height of cut
88 kg (195 pounds)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Checking the Engine Oil Level

Service Interval: Before each use or daily
The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started.
Crankcase capacity is approximately 2.8 liters (4 quarts) with
the filter.
Use high-quality engine oil that meets the following
specifications:
•
API Classification Level Required: CH-4, CI-4 or higher.
•
Preferred oil: SAE 15W-40 (above 0ºF (-17ºC))
•
Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
Note: Toro Premium Engine oil is available from your
distributor in either 15W-40 or 10W-30 viscosity. See the
parts catalog for part numbers.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level
is at or below the "add" mark on the dipstick, add oil to bring
the oil level to the "full" mark. DO NOT OVERFILL. If
the oil level is between the "full" and "add" marks, no oil
addition is required.
1. Position the machine on a level surface.
2. Remove the dipstick (Figure 25) and wipe it with a
clean rag.
1. Dipstick
3. Push the dipstick down into the dipstick tube and make
sure that it is seated fully. Pull the dipstick out and
check the oil level.
4. If the oil level is low, remove the oil fill cap (Figure 26)
and gradually add small quantities of oil, checking the
25
Figure 25