Engine Maintenance; Servicing The Air Cleaner - Toro 30807 Operator's Manual

Figure 48
•
Cutting unit spindle shaft bearings (2 per cutting unit)
(Figure 49)
Note: Either fitting can be used, which ever is more
accessible. Pump grease into the fitting until a small
amount appears at bottom of the spindle housing (under
the deck).
Figure 49
•
Rear roller bearings (2 per cutting unit) (Figure 50)
Figure 50
Note: Make sure the grease groove in each roller mount
aligns with the grease hole in each end of the roller
shaft. To help align the groove and hole, there is also an
alignment mark on one end of the roller shaft.
Important: Do not lubricate the Sidewinder cross
tube. The bearing blocks are self-lubricated.

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Every 200 hours (More frequently in
•
•
•
1. Release the latches securing the air cleaner cover to the
1. Air cleaner cover
2. Remove the cover from the air cleaner body.
3. Before removing the filter, use low pressure air (40 psi,
G011349
4. Remove and replace the primary filter (Figure 52).
44
extreme dusty or dirty conditions)
Check the air cleaner body for damage which could cause
an air leak. Replace if damaged. Check the whole intake
system for leaks, damage, or loose hose clamps.
Service at the recommended service interval or earlier if
engine performance suffers due to extremely dusty, dirty
conditions. Changing the air filter before it is necessary
only increases the chance of dirt entering the engine when
the filter is removed.
Be sure the cover is seated correctly and seals with the
air cleaner body.
air cleaner body (Figure 51).
Figure 51
clean and dry) to help remove large accumulations of
debris packed between outside of primary filter and
the canister. Avoid using high pressure air which could
force dirt through the filter into the intake tract. This
cleaning process prevents debris from migrating into
the intake when the primary filter is removed.
Cleaning of the used element is not recommended due
to the possibility of damage to the filter media.
2. Air cleaner latch