Checking The Angle Indicator(Models 30839, 30843 And 30807 Only); Installing The Ce Decals - Toro 30807 Operator's Manual

1. Positive (+) battery cable
Important: If the battery is ever removed, make
sure that the battery clamp bolts are installed with
the bolt heads positioned on the bottom side and
the nuts on the top side. If the clamp bolts are
reversed, they may interfere with the hydraulic
tubes when shifting the cutting units.
8. Coat both battery connections with Grafo 112X (skin
over) grease, Toro Part No. 505-47, petroleum jelly, or
light grease to prevent corrosion.
9. Slide the rubber boot over the positive terminal to
prevent a possible short from occurring.
10. Install the battery cover.
2
Checking the Angle Indicator
(Models 30839, 30843 and
30807 only)
Parts needed for this procedure:
1 Inclinometer
Procedure
DANGER
To reduce risk of injury or death due to rollover, do
not operate the machine on side hills steeper than
25º.
1. Park the machine on a flat, level surface.
2. Verify that the machine is level by placing a hand held
inclinometer (supplied with the machine) on the frame
cross rail, by the fuel tank (Figure 5). The inclinometer
should read zero degrees when viewed from the
operator's position.
Figure 4
2. Negative (–) battery cable
1. Angle indicator
3. If the inclinometer does not read zero degrees, move
the machine to a location where a zero degree reading
is obtained. The angle indicator, mounted on the
machine, should now read zero degrees as well.
4. If the angle indicator does not read zero degrees,
loosen the two screws and nuts securing the angle
indicator to the mounting bracket, adjust the indicator
to obtain a zero degree reading, and tighten the bolts.
3

Installing the CE Decals

Parts needed for this procedure:
1 Warning decal (104–5181)
1 Warning decal (99–3558)
3 Warning decal (107–1972)
Procedure
If this machine will be used for CE, affix the CE warning
decals over the corresponding English warning decals.
17
Figure 5