Table of Contents
Advertisement
2
Figure 41
1. Alignment marker
2. Cut grass on left
4. As the front of the baskets cross the edge of the green,
depress the lift pedal.
Note: This will stop the reels and lift the cutting units.
Timing of this procedure is important, so the mowers
do not cut into the fringe area. However, as much of
the green as possible should be cut to minimize the
amount of grass left to mow around the outer periphery
5. Cut down on operating time and ease lineup for the
next pass by momentarily turning the machine in the
opposite direction, then turning in the direction of the
uncut portion; i.e., if intending to turn right, first swing
slightly left, then right.
Note: This will assist in getting the machine more
quickly aligned for the next pass.
Follow the same procedure for turning in the opposite
direction. It is a good practice to try to make as short
of a turn as possible. However, turn in a wider arc
during warmer weather to minimize the possibility of
bruising the turf.
Important: The machine should never be stopped
on a green with the cutting unit reels operating
as damage to the turf may result. Stopping on a
wet green with the machine may leave marks or
indentations from the wheels.
6. Finish cutting the green by mowing the outer periphery
and replace the flags.
Note: Be sure to change the direction of cutting from
the previous mowing. Always keep weather and turf
conditions in mind and be sure to change the direction
of mowing from the previous cutting.
3
1
G017821
3. Keep focal spot 1.8-3
m (6-10 ft) ahead of the
machine.
Note: At the end of the periphery cut, momentarily
pull back on the raise/lower mow lever to shut the reels
off without raising them. Continue moving forward
until the reel stops rotating, then, drive off the green
and raise the reels (This will help prevent dribbling
grass onto the green while raising the reels).
7. Empty the grass baskets of all clippings before
transporting to the next green.
Note: Heavy wet clippings place an undue strain on
the baskets and will add unnecessary weight to the
machine, thereby increasing the load on the engine,
hydraulic system, brakes, etc.
Driving the Machine without
Mowing
Make sure the cutting units are in the full up position. Move
the functional control lever to the transport position. Use
the brakes to slow the machine while going down steep
hills to avoid loss of control. Always approach rough areas
at a reduced speed and cross severe undulations carefully.
Familiarize yourself with the width of the machine. Do not
attempt to pass between objects that are close together so
that costly damage and down time can be prevented.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can lead
to accidents causing personal injury.
Do not drive machine on a public street or roadway.
To transport the machine:
1. If using a trailer, connect it to the towing vehicle and
connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Stop the engine, remove the key, set the brake, and
close the fuel valve.
5. Use the metal tie down loops on the machine to
securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes.
33
Advertisement
Table of Contents
