Toro 04540 Operator's Manual page 31

1
Figure 36
1. Latch—closed position
2. Suspension-arm bar
1
2
Figure 37
1. Suspension-arm bar
5. Close the latches down and around the cutting-unit bar
and lock them in place
Note: A "click" can be heard and felt when the latches
are properly locked in place.
6. Coat the spline shaft of the cutting unit motor with
clean grease (Figure
7. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure
2
3. Latch—open position
2. Cutting-unit bar
(Figure 36).
38).
38).
3
g014609
1. Reel motor
2. Spline shaft
8. Mount a grass basket onto the basket hooks on the
suspension arm.
9. Repeat this procedure for the other cutting units.
10. Connect the cutting unit power disconnect couplers;
g01461 1
refer to
(page 24).
Removing the Cutting Units
1. Disconnect the cutting unit power disconnect couplers;
refer to
(page 24).
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
2. Park the machine on a clean level surface, lower
the cutting units to the ground until the suspension
hydraulics are fully extended, stop the engine, and set
the parking brake.
3. Push the motor retaining bar out of the slots on the
motor towards the cutting unit and remove the motor
from the cutting unit.
31
Figure 38
3. Cavity
4. Motor-retaining bar
Cutting Unit Power Disconnect Connectors
Cutting Unit Power Disconnect Connectors