Toro 04540 Operator's Manual page 21

Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Engine Run
Glowplugs
Fan
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your Authorized
Toro Distributor for more
information on the Faults
menu and the information
contained there.
The Service menu contains
information on the machine
such as hours of use and other
similar numbers.
The Diagnostics menu
lists various states that the
machine currently has. You
can use this to troubleshoot
certain issues as it will quickly
tell you which machine
controls are on and which are
off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine,
reels, backlap, and fan have
been on, as well as the
number of hours the machine
has been transported and
overheated.
Lists the number of preheats
and starts the machine has
experienced.
Description
Indicates if the following items
are active: Key start, key run,
joystick lower, joystick raise,
neutral, seat or parking brake,
OK run, and RTR or ETR.
Indicates if the following items
are active: Key start, timeout
limited, and glowplugs.
Indicates if the fan is active
in the following instances:
Engine high temp, oil high
temp, engine or hydraulic high
temp, and fan on.
S1–S4
Reels Enable
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Protection Settings
Reset Defaults
Raise Delay
Lower Delay
Tapoff Delay
Reel Speed
Backlap rpm
About
Menu Item
Model
SN
TEC 5001
InfoCenter
CU1
CU2
CU3
Generator
CAN Bus
21
Controls the raising and
lowering of the solenoids.
Indicates if the eReel is
enabled.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric.
Controls the language used
on the InfoCenter.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows the distributor/engineer
to access protected menus by
inputting a passcode.
Controls the protected menus.
Resets the InfoCenter to
default settings.
Controls the raise delay time
for the center cutting unit.
Controls the lower delay for
the center cutting unit.
Controls the tap-off delay.
Controls the reel speed.
Controls the backlap rpm
speed.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the software revision of
the first cutting unit.
Lists the software revision of
the second cutting unit.
List the software revision of
the third cutting unit.
Lists the serial number of the
generator.
Lists the machine
communication bus status.