Table of Contents
Advertisement
Cutting Unit Power Disconnect
Connectors
Before installing, removing, or working on the cutting
units, disconnect the cutting units from the power supply
by separating the cutting unit power disconnect connectors
(Figure
26), located at the base of the rollover bar on the left
side of the traction unit. Plug the connectors together before
operating the machine.
Figure 26
1. Cutting unit power disconnect connector
CAUTION
If you do not disconnect the power to the cutting
units, someone could accidentally start the cutting
unit, causing serious injury to hands and feet.
Always separate the cutting unit power disconnect
connectors before working on the cutting units.
Specifications
Note: Specifications and design are subject to change
without notice.
Width of cut
Wheel tread
Wheel base
Overall length (w/baskets)
Overall width
Overall height
Net Weight w/reels (11 Blade)
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
24
151 cm (59.5 inches)
128 cm (50.5 inches)
123 cm (48.6 inches)
249 cm (98.0 inches)
179 cm (70.62 inches)
205 cm (80.83 inches)
Refer to the traction unit
serial tag
(Figure
1).
Advertisement
Table of Contents
