Installing The Grass-Basket Hooks; Installing The Cutting Units - Toro 04540 Operator's Manual

Traction unit
Hide thumbs Also See for 04540:
Table of Contents

Advertisement

WARNING
Battery terminals or metal tools could short
against metal tractor components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the tractor.
• Do not allow metal tools to short between
the battery terminals and metal parts of
the tractor.
WARNING
Failure to correctly activate the battery may
result in battery gassing and/or premature
battery failure.
7. Place the battery on the battery tray and secure it with
the battery clamp and fasterners removed previously.
8. Install the positive cable (red) to the positive (+)
terminal and then the negative cable (black) to the
negative (–) terminal of the battery and secure them
with the bolts and nuts
boot over the positive terminal to prevent a possible
short from occurring.
WARNING
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can cause
the battery gasses to explode, resulting in personal
injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
1. Negative (-)
2. Positive (+)
(Figure
7). Slide the rubber
Figure 7
5
Installing the Grass-Basket
Hooks
Parts needed for this procedure:
6
Grass-basket hook
12
Flange bolts
Procedure
Install the 6 grass-basket hooks onto the ends of the
suspension-arm bars using the 12 flange bolts
1. Flange bolt
2. Grass-basket hook
6

Installing the Cutting Units

Parts needed for this procedure:
1
Gauge bar
3
Cutting unit (model 04613, 04614, or 04615)
3
Cutting-unit upper weight
6
Hex-head bolts
3
Grass Basket
Procedure
Note: When sharpening, setting the height-of-cut, or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the storage location
15
(Figure
Figure 8
3. Suspension-arm bar
8).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Greensmaster 3420 triflexGreensmaster 3420

Table of Contents