Inspecting And Cleaning After Mowing; Driving The Machine Without Mowing; Hauling The Machine - Toro Greensmaster TriFlex 3420 Operator's Manual

1. Alignment strip
2. Approximately 12.7 cm (5
inches)
Note:
Due to the nature of the power steering
system, the steering wheel will not return to its
original position after a turn has been completed.
Important:
Never stop on a green with
the cutting unit reels operating as damage
to the turf may result. Stopping on a wet
green with the machine may leave marks or
indentations from the wheels.
7. If the leak detector alarm sounds while cutting
on a green, immediately raise the cutting units,
drive directly off the green and stop the machine
in an area away from the green. Determine the
cause of the alarm and correct the problem.
8. Finish cutting the green by mowing the outer
periphery. Be sure to change the direction of
cutting from the previous mowing.
Note:
Always keep weather and turf conditions
in mind and be sure to change the direction of
mowing from the previous cutting.
9. When finished mowing the outer periphery, tap
the raise/lower mow lever rearward to stop the
reels, then drive off the green. When all of the
cutting units are off of the green, raise them.
Note:
This minimizes grass clumps left on the
green.
10. Replace the flag.
11. Empty the grass baskets of all clippings before
transporting to the next green.
Note:
Heavy wet clippings place an undue
strain on the baskets and adds unnecessary
Figure 36
3. Cut grass on the left
4. Keep a focal spot 2 to 3
m (6 to 10 ft) ahead of the
machine.
weight to the machine, thereby increasing the
load on the engine, hydraulic system, brakes,
etc.
Inspecting and Cleaning
after Mowing
After mowing, thoroughly wash the machine with
a garden hose without a nozzle so that excessive
water pressure will not contaminate and damage the
seals and bearings. Never wash a warm engine or
electrical connections with water.
After cleaning, inspect the machine for possible
hydraulic fluid leaks, damage or wear to hydraulic
and mechanical components, and the cutting units
for sharpness. Also, lubricate brake shaft assembly
g005116
with SAE 30 oil or spray lubricant to deter corrosion
and help keep the machine performing satisfactorily
during the next mowing operation.
Driving the Machine without
Mowing
Ensure that the cutting units are fully raised. Move
the functional-control lever to the T
Use the brakes to slow the machine while going down
steep hills to avoid loss of control. Always approach
rough areas at a reduced speed and cross severe
undulations carefully. Familiarize yourself with the
width of the machine. Do not attempt to pass between
objects that are close together so that costly damage
and down time can be prevented.

Hauling the Machine

•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use a full-width ramp for loading the machine into
a trailer or a truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
35
position.
RANSPORT