Table of Contents
Advertisement
on the front of the suspension arms to prevent damage to
them.
Important: Do not raise the suspension to the transport
position when the reel motors are in the holders in the
machine frame. Damage to the motors or hoses could
result.
Important: Whenever the cutting unit has to be tipped
to expose bedknife/reel, prop up rear of cutting unit to
make sure nuts on back end of bedbar adjusting screws
are not resting on work surface
g014596
1. Prop (not provided)
Note: All cutting units are shipped with the counter weight
mounted to the right end and the motor mount and drive
coupler mounted to the left end of the cutting unit.
1. Disconnect the cutting unit power disconnect couplers;
refer to
Cutting Unit Power Disconnect Connectors
(page
24).
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
2. Apply grease to the inside diameter of the drive coupler.
3. The cutting unit is shipped without a front roller.
Obtain a roller (Models 04625, 04626, or 04627) from
your local Toro Distributor. Install the roller using
the loose parts supplied with the cutting unit and
installation instructions included with the roller.
4. Remove the 2 bolts securing the weight to the side of
the cutting unit
(Figure
(Figure
9).
2
2
1
Figure 9
2. Bedknife adjusting nut (2)
10).
2
3
1
1. Cutting-until weight (flip
over)
2. Upper weight
5. Rotate the weight 180 degrees so that the open screw
holes that were on the underside of the weight are now
on top. Install the weight to the cutting unit using the
bolts removed previously.
6. Install an upper weight to the cutting unit weight using
2 hex head screws
7. If installing the center cutting unit, lift up on the foot
rest and swing it up, allowing access to the center
cutting unit position
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
1. Footrest—closed
8. Position the cutting unit under the suspension arm.
16
Figure 10
3. Hex-head bolts
(Figure
10).
(Figure
11).
2
Figure 11
2. Footrest—open
g016294
g014602
Advertisement
Table of Contents
