Lubrication
Greasing the Machine
Lubricate the grease fittings regularly with No. 2 General
Purpose Lithium-Base Grease. If the you operate the machine
under normal conditions, lubricate all bearings and bushings
after every 50 hours of operation.
Locate the grease fitting as follows:
•
Rear roller hub assembly or, if equipped with a 3-wheel
drive kits, rear wheel roller clutches and external ball
bearing (1) (Figure 35)
Figure 35
•
Steering fork shaft (1) (Figure 36)
•
Steering cylinder rod end (Figure 36)
Figure 36
•
Lift arm pivot (3) and pivot hinge (3) (Figure 37)
•
Pull frame shaft and roller (12) (Figure 38)
•
Steering cylinder end (Figure 39)
G017144
31
Figure 37
Figure 38
Figure 39