Installing The Battery; Installing The Roll Over Protection System (Rops) - Toro 04358 Greensmaster 3150 Operator's Manual

2-wheel drive traction unit
Hide thumbs Also See for 04358 Greensmaster 3150:
Table of Contents

Advertisement

WARNING
Failure to correctly activate the battery may
result in battery gassing and/or premature
battery failure.
7. Install the vent caps.
2

Installing the Battery

Parts needed for this procedure:
2
Bolt (1/4 x 5/8 inch)
2
Nut (1/4 inch)
Procedure
1. Mount the battery with the battery terminals toward
the front of the machine.
2. Connect the positive battery cable (red) from the
starter solenoid to the positive post (+) of the battery
(Figure 5). Secure it with a wrench and coat the
terminal with petroleum jelly. Make sure the cable will
clear the seat, in the rear-most position, which could
cause wear or damage to the cable.
WARNING
Battery terminals or metal tools could short
against metal tractor components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the tractor.
• Do not allow metal tools to short between
the battery terminals and metal parts of
the tractor.
1. Negative (-)
3. Connect the black ground cable (from the engine base)
to the negative (-) post of the battery. Secure it with a
wrench and coat the terminal with petroleum jelly.
WARNING
Incorrect battery cable routing could damage
the tractor and cables causing sparks. Sparks
can cause the battery gasses to explode,
resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
4. Install the battery clamp and washers and secure them
with the wing nuts.
5. Place the terminal cover over the positive (+) battery
post.
3
Installing the Roll Over
Protection System (ROPS)
Parts needed for this procedure:
8
Bolt (1/2 x 1.75 inch)
8
Nut (1/2 inch)
Procedure
1. Remove the screws and nuts supporting the jack pad
on the right side of the machine.
13
Figure 5
2. Positive (+)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Greensmaster 3150

Table of Contents