Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 04358 Greensmaster 3150 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Overall Width w/reels
Overall Length
Overall Height
Overall Weight w/11–blade
cutting units
Net Weight (dry)
Width of Cut
Wheel Tread
Wheel Base
Mow Speed (adjustable)
Transport Speed
Reverse Speed
Reel Speed (at 2,850 RPM
engine speed)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
177 cm (69–3/4 inches)
228.6 cm (90 inches)
189 cm (74-1/2 inches)
583 kg (1,374 lb)
493 kg (1,087 lb)
149.9 cm (59 inches)
125.7 cm (49-1/2 inches)
119.1 cm (46-7/8 inches)
3.2–8 km/h (2–5 mph)
approximately
12.9 km/h (8.0 mph)
approximately
4 km/h (2.5 mph)
1,845 rpm approximately
19

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and symbols
in the safety section. Knowing this information could help
you or bystanders avoid injury.
The use of protective equipment, such as but not limited to,
for eyes, ears, feet, and head is recommended.
CAUTION
Use your seat belt while operating this machine.

Checking the Engine Oil

The engine is shipped with 1.4 liters (1.5 quarts) (w/filter) of
oil in the crankcase; however, the oil level must be checked
before and after the engine is first started.
The engine uses any high-quality detergent oil having the
American Petroleum Institute (API) service classification of
SG, SH, or SJ or higher. The recommended viscosity (weight)
is SAE 30.
1. Position the machine on a level surface.
2. Pull the dipstick out and wipe it with a clean rag. Push
the dipstick into the tube and make sure it is seated
fully (Figure 20).
2
G017134
Figure 20
1. Dipstick
3. Pull the dipstick out of the tube and check the oil level.
4. If the oil level is low, remove the filler cap from the
valve cover and pour oil into the opening in the valve
cover until the oil level is up to the Full mark on the
dipstick. Add the oil slowly and check the level often
during this process. Do not overfill.
Important: Check the oil level every 8 operating
hours or daily.
1
2. Filler cap