Fuses; Backlapping - Toro 04383 Greensmaster 3250-D Operator's Manual

Fuses

The fuses in the machine's electrical system are located
under the seat (Fig. 57).
Figure 57
1. Fuses

Backlapping

Warning
Contact with the reels or other moving parts can
result in personal injury.
• Keep fingers, hands, and clothing away from the
reels or other moving parts.
• Never attempt to turn the reels by hand or foot
while the engine is running.
1. Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking brake.
2. Unlock and raise the seat to expose the controls.
3. Make initial reel to bedknife adjustments appropriate
for backlapping on all cutting units which are to be
backlapped; refer to the cutting unit Operator's Manual.
Danger
Changing the engine speed while backlapping may
cause the reels to stall.
• Never change the engine speed while
backlapping.
• Only backlap at idle engine speed.
4. Start the engine and run at low idle speed.
5. Rotate the Backlap Lever to the "R" position (Fig. 58).
6. Rotate the Reel Speed Control to setting 1 (Fig. 58).
1
10A
10A
1. Backlap lever
15A
OPEN
7. With the Mow/Transport lever in the neutral position,
move the Lower Mow/Lift control forward to start the
backlapping operation on the designated reels.
8. Apply lapping compound with a long handle brush.
Never use a short handled brush.
9. If the reels stall or become erratic while backlapping,
select a higher reel speed setting until the speed
stabilizes, then return the reel speed to setting 1 or to
your desired speed.
10. To make an adjustment to the cutting units while
backlapping, turn the reels off by moving the Lower
Mow/Raise lever rearward and stop the engine. After
completing adjustments,repeat steps 4 through 8.
11. Repeat the procedure for all cutting units you want to
backlap.
12. When finished,return the backlap levers to the "F"
position, lower the seat, and wash all lapping compound
off of the cutting units. Adjust cutting unit reel to
bedknife as needed. Move the cutting unit reel speed
control to the desired mowing position.
Important
"F" position after backlapping, the cutting units will not
raise or function properly.
40
2
Figure 58
2. Reel speed control
If the backlap lever is not returned to the
1