Toro 04383 Greensmaster 3250-D Operator's Manual page 17

D. Remove the snap ring securing the drive coupler in
the reel tube (Fig. 15). Remove the drive coupler.
1
Figure 15
1. Snap ring
E. Apply grease to the inside diameter of the drive
coupler. Install the drive coupler to the left end of
the cutting unit reel tube with a snap ring.
F. Install the motor mount to the left end of the cutting
unit with the (2) allen head screws previously
removed. Torque screws to 12–15 ft–lbs. (16–20
N⋅m).
G. Install the counter weight to the right end of the
cutting unit with the screws previously removed.
4. The cutting unit is shipped without a front roller. Obtain
a roller (Model No. 04625, 04626 or 04627) from your
local Toro Distributor. Install the roller using the loose
parts supplied with the cutting unit and installation
instructions included with the roller.
5. Thread a ball stud into each end of the cutting unit front
roller (Fig. 16).
Figure 16
1. Ball stud
6. Slide the cutting unit under the pull frame while
hooking the lift roller onto the lift arm. To facilitate
installation of the rear cutting unit, the pull frame can
be rotated and latched into a service position:
2
2. Drive coupler
1
17
A. Lower the suspension system completely (cylinders
extended).
B. Lift the carrier frame by hand until the anti-scalp
rollers clear the brake linkage.
C. Lift up on the slotted link and rotate the pull frame
into the wire hook (Fig. 17).
2
Figure 17
1. Slotted link
D. With the cutting unit in position, release the wire
hook and rotate the pull frame to the operating
position.
E. The slotted link locks automatically.
F. Attach the motor and pull links.
Important
Do not operate the lift system when the
center cutting unit is in the service position. Damage could
result to the pull frame and clevis assembly.
7. Slide the sleeve back on each ball joint receiver and
hook the receiver onto the cutting unit ball stud
(Fig. 18).
1
2
Figure 18
1. Pull link extension
2. Pull arm
1
2. Wire hook
3
3. Ball joint receiver