Toro 04383 Greensmaster 3250-D Operator's Manual page 16

Important
Whenever the cutting unit has to be tipped
to expose bedknife/reel, prop up rear of cutting unit to
make sure nuts on back end of bedbar adjusting screws are
not resting on work surface (Fig. 11).
1
Figure 11
1. Prop (not provided)
1. Remove the cutting units from the cartons. Assemble
and adjust them per the Operator's Manual for the
cutting units. Use the Height Gauge bar from the Loose
Parts Kit to adjust the height of cut.
2. Install the offset lift hook (Fig. 12) to the top of the
cutting unit with (2) M10–1.5 capscrews. Torque the
capscrews to 25–30 ft–lbs. (34–40 N⋅m). The offset lift
hook should be positioned with hook forward.
1
Figure 12
1. Offset lift hook
2
2. Bedknife adjusting screw
nut (2)
3. All cutting units are shipped with the counter weight
mounted to the left end and the motor mount and drive
coupler mounted to the right end of the cutting unit. To
mount the cutting unit in the right front position,
proceed as follows:
A. Remove the 2 capscrews securing the counter
weight to the left end of the cutting unit. Remove
the counter weight (Fig. 13).
1. Counter weight
B. On right end of cutting unit, remove plastic plug
from bearing housing (Fig. 14).
C. Remove the 2 allen head screws securing the motor
mount to the right end of the cutting unit. Remove
the motor mount (Fig. 14).
3
1. Motor mount
2. Plastic plug
16
1
Figure 13
1
2
Figure 14
3. Allen head screw (2)